Scroll Saw Blade Types Reviews

Scroll Saw Blade Types

When it comes to choosing which type of scroll saw blade to install on a scroll saw, there are a variety of choices. Scroll saw blades come in two major types: pin end and plain end. The plain-end is a type of blade that is completely flat and is pinched in place between the jaws of small clamps on the scroll saw. The pin-end has a tiny cross pin in each end. The main difference between the two types of blades is the cross pin. The plain end blades are five inches long, will fit almost all types of scroll saws and are more widely available.

There are several types of plain end blades:
Scroll Saw Blade Types Reviews

1. Standard Tooth

On standard tooth blades, the teeth have indistinguishable sizes and are equally spread out. Wood blades and metals blades are the two noteworthy sorts. Bigger teeth and bigger spaces between the teeth are found on wood blades. The outline is expected to clear sawdust as one makes cuts. Not so, metal blades have a lot smaller enamel and a lesser number of spaces in between teeth. Some will get these to be a bit raucous.

2. Skip-tooth

These blades and standard blades are quite similar. The one thing that distinguishes the two is that with the skip-tooth every other tooth is missing. The gullet, the space between the teeth, is wider and this also helps to keep the blade cool. Most prefer these types of blades. These types of blades are also recommended for newbie scroller sawers.

3. Double-tooth

The double-tooth blade is similar to the skip-tooth blade but the double-tooth has a bigger gullet between two teeth sets. The double-tooth types can produce a very smooth cut; however they can cut a bit slower.

4. Reverse Skip-tooth

The reverse skip-tooth blade is identical to the skip-tooth blade; however the teeth that are found at end of the bottom row point up. When working with plywood and for preventing tear-out splintering at the bottom of the cut, the reverse-skip tooth blade will work very well.

One must remember that when working with a reverse skip-tooth blade one must set the blade in a specific manner. When the saw arm is in its highest position, the blade should be set in the clamps so there are only two to three teeth that are protruding above the table top. If you are not able to do this, you might have to take a little bit off from the bottom of the blade.

When working with specialty materials, it is important to remember that these require special blades. A tip to remember when cutting is to use strapping tape to mark along where you are going to cut. This will help make the cut smoother and cleaner and will also reduce the chances of the plastic getting hot and fusing back together. This will also work with wood. The tape will help reduce the friction between the blade and the material. You can also try dry lubricants.

A very important thing to keep in mind is not to try rush the cutting. The reason for this is that your finger could slip and make contact with the sharp blade and if you try to push hardwoods and other tough materials too fast, the blade could turn sideways. The will cause a skewed cut or bent blade.